This is default featured slide 1 title
This is default featured slide 2 title
This is default featured slide 3 title
This is default featured slide 4 title
This is default featured slide 5 title
 

Repaint Jeep Wheels

The first thing is removing the Jeep wheels in pairs. Untie the lug nuts on the front wheels and lift the jeep with a car lift. Ensure the jack is securely standing on the vehicle. Lower the Jeep lifts until an equal weight is distributed between the lift and jack stands.

Use the 400-grit sandpaper to sand the Wheels, rub as if you are washing the Jeep. Ensure you keep the sandpaper wet the entire time. Use water from a bucket or running water hose pipe. The water is usually used to keep build-up of the old paint from scratching into the surface of the wheel. Sand the surface until the wheel feels smooth to the hand. Remove any rough spots and any scratches or surface rust.

After removing the dirt apply degreaser. Once applied, wash the Jeep wheel off with water. Allow the wheel ample time to dry completely. Apply masking tape on the tires sidewall and also around the tire’s valve stem this is to limit the overspray from the paint. Ensure that no parts of the wheel are masked. Use the adhesive promoter and spray the primer in light thin coats so that it fills all parts of the wheel. Each coat should be sprayed within two to three minutes. Let it dry.

Use the 1200-grit sand paper and wipe the Jeep wheel down. Sand down any areas which were contaminated. If necessary, you can reapply the primer. Wash this area with water after final sanding. Then, use rubbing alcohol and a cloth to clean the entire area.

Finally, you spray the wheel with colour coat rim paint. Apply two to three light coats, this limits dripping of the paint. Ensure you keep the nozzle eight to twelve inches away from the wheel surface and also apply in a back to forth motion. Allow the paint to dry for at least 30 minutes and remove the masking tape.